Toshiba Strata DK 280 Installation Manual page 753

c
Table 2
Paging Group and Zone Codes
User Programmable Feature Buttons
Paging Group Codes Paging Zone Codes
# 3 1 I-Group A # 3 1 5-Group E # 3 SZone A
# 3 1 Z-Group B # 3 1 6-Group F # 3 &Zone 6
# 3 13-Group C # 3 17-Group G # 3 'I-zone c
# 3 1 &-Group D # 3 1 R-Group H # 3 O-Zone D
# 3 O-All Call Page group.
# 3 9-All Call Page group and possibly external page zones,
depending on system programming.
Table 3
Call Pickup Codes
To Pick Up Dial
I
n A call ringing or held at a station
n A telephone group page, internal call,
or door phone call ringing a station
H An external page
n A CO line on hold
n A ringing CO line
St;tb;rPrimary Directory
#5#30
#5#35
#5+#7OOI-#7144
#59
You can store this sequence onto an SD button for one-touch access. See '"To
Store on a Button" in the following User Programmable Feature Buttons
section.
82
You can program Speed Dial buttons or codes to access features. as well as
telephone numbers. You can store up to 20 digits, enabling you to access a
sequence of features, such as Call Park and Page, with a code in a Speed Dial
button. A list of feature access codes in Table 4 follows the storage instructions
for this feature.
To Store on a Button:
1.
2.
3.
4.
5.
Do not lift the handset.
Press RDL.
Press one of the SD
buttons.
Enter a feature access
code or sequence of
codes. (See Table 4 on
next page.)
Press RDL.
To Store in a System or
Station Speed Dial Location:
1.
2.
3.
4.
5.
Do not lift the handset.
Press RDL, then press
SD.
Dial a Speed Dial
access code.
Enter a feature access
code or sequence of
codes.
press RDL.
If you lifted the handset in Step 1, the system would automatically dial the
number that you most recently dialed
You can program the CONFfI'RNS, [PDN] and HOLD functions within the
Speed Dial sequence.
You can only enter 20 digits maximum. Dial pad digits count as 1 digit, while the
CONF/TRNS, [PDN] and HOLD feature buttons each count as two.
The feature access cods or codes should be stored in memory.
Note:
If the preceding sequence is not completed within one or three minutes
(system programmable time), the operation will time out and your
telephone will be placed in the idle condition.
If you lifted the handset in Step 1, the system would automatically dial the
number that you most recently dialed after you press the RDL button.
If your station doss not have the SD button. dial t instead.
Station Speed Dial locations are 1 0 - 4 9. System Speed Dial locations are
6 0 0 - 6 9 9 or 6 0 - 9 9 and can onlv be stored at Station 200 or at Attendant
Co"soles.
You can only enter 20 digits maximum. Dial pad digits count as 1 digit, while the
CONF/TRNS, [PDN], and HOLD feature buttons each count as two.
Note:
Refer to Table 4 for a list of access codes, although the sequences in the
tab/e tell how to store access codes on SD buttons.
The feature access code or codes are stored in memory.
Note:
To exit the entry mode to answer or make a Cal, press the RDL button.
83