Toshiba Strata DK 280 Installation Manual page 567

Program *81, *84,
and
*87 -
Ground/Loop Start/CO Line to Directory
Number Button LED Flash Assignments
(073 - 144) (R3)
~~lr;l~~~~~~~--iSpkrnnola--IspkrilinrH~~nnn-lSpkrl~(iil~-~j~~l
Enter:
-Enter the Port Number of the LED that
should flash:
1,4, or 7
Primary [DN]: Port 000 - 239 (Prg 04)
Phantom
[DN]:
Port 500 - 739 (Prg *04)
Button 01 enters blank data.
113
114
115
116
117
118
,,a
Note:
OK0399
--mm
7. To enter a CO line range, enter:
[mnnrjrjr~ inp'aceof: I II II II#I
Low CO linr
LHigh CO line
General Notes:
*
initialized data: no Directory Numbers [DNs] assigned to ring.
.
If a CO line is assigned to flash a [DN] in this program, the assigned [DN] LED will flash as 1 Hz rate when the CO line rings into the
DK280; use Program 81 - 89 to assign the telephones equipped with the [DN] to ring as required.
IMPORTANT!
If CO /ines direct ring VM ports via Program
87 - 89, the data in Programs w?l, @4, and x87
must be blank.
.
The CO line that is assigned to flash a [DN] in Program Ml, W#, and *7 should also be assigned to ring the telephones on which the
[DN] appears. CO lines are assigned to ring telephones using Program 81 - 89.
.
If the CO line button is programmed (Program 39) to appear on a telephone, do not assign a [DN] to flash on that telephone with Program
til, *84, andx87.
l
See CO /inedDN] button LED control logic diagrams that follow these record sheets.
I
February 1996
1 o-1 53