Cabinet Installation; Inspection. Packaging And Storage; 3.1.1 Inspection; Packaging And Storage - Toshiba Strata DK 280 Installation Manual

Cabinet Installation

This chapter explains how to install the Strata DK280
base (DKSUB280) and expansion (DKSUE280 or
on how to remove and replace cabinets on installed
systems.
This chapter also describes how to install ground
wiring, AC power cabling, reserve power (Battery
Backup) cabling, and printed circuit board (PCB)
.
cabling
3.1 Inspection, Packaging and
Storage

3.1.1 Inspection

When the system is received, examine all packages
carefully and note any visible damage. If any damage
is found, do not open the packages. Contact the
delivery carrier immediately and make the proper
claims.
After unpacking (and before installing), check the
system against the packing list and inspect all
equipment for damage. If equipment is missing
damaged, contact your supplier immediately.
Be sure to retain original packaging materials for re-
use when storing or transporting system hardware.
3.1.2

Packaging and Storage

CAUTION !
When handling (installing, removing,
examining) PCBs, do not touch the back
(soldered) side or edge connector. Always
hold the PCB by its edges.
January 1996
When packaging and storing the system, remove
PCBs from the system cabinet (the power supply may
remain installed in the cabinet for storage and
shipment). PCBs should be packaged in their original
antistatic bags for protection against electrostatic
discharge. Be sure to package equipment in its
original shipping containers.
3.2 Cabinet Installation
Considerations
The base (DKSUB280) and expansion cabinets
mounted. To make it easier to add cabinets (after the
initial installation) when a customer needs to expand,
it is recommended that the base cabinet be installed
on top in wall-mount installations and on the bottom in
floor-mount installations
The dimensions of the base and expansion cabinets
are as follows:
Height: base cabinet: 11 3/4 inches
Height: expansion cabinet: 10 inches
or
Width: 23 5/8 inches
Depth: 9 314 inches
Weight: approx. 30.5 Ibs. (14 kg.)
Note:
The weight approximates a cabinet
completely filled with PCBs. Weight may vary
slightly, depending on PCBs.
It is recommended that the cabinets be installed in the
following order:
3.3).
.