Led Indications; On-Hook/Off-Hook - Toshiba Strata DK 280 Installation Manual

c
Exclusive Hold-When you place an outside call on Exclusive Hold:
LED Indications
n
Each line and feature button has a Light Emitting Diode (LED) next lo it which
indicates the status of the line or feature associated with the button.
CO or [DN] LEDs flesh at varying rates to indicate call status.
CO or [DN] In-use-When you access an outside line:
n Your station's CO or [DN] LED flashes -2 seconds on--118 second off-i/a
second on and l/8 second off.
n Other stations' CO or [DN] LEDs that show your station: steady red.
incoming Call-While en incoming call is ringing:
n Your station's CO or [DN] LED flashes --one second on/one second off.
n Other stations' CO or [DN] LEDs that show your station flash red-one
secondonandonesecondoff.
Camp-on Busy-When another station camps on to your station:
n Your station's CO or [DN] LED flashes -l/2 second on1112 second off.
On Hold-When you place en outside line on hold:
n Your station's CO or [DN] LED flashes 4 pulses per second for l/8 second
then l/8 second off.
n Other stations' CO or [DN] LEDs that show your station flash red-314
second on then II4 second off.
Note:
If using a PI. button, the hold indication is only at the station that places
the call on hold.
Consultation Hold-During a consultation or transfer lo another station:
n Your station's CO or [DN] LED flashes -ten pulses per second.
-
Your station's CO or [DN] LED flashes --ten pulses per second.
Other stations' CO or [DN] LEDs that show your station: steady, red.
Hold Recall/Exclusive Hold Recall-When a held call is recalling your Idle
station:
+ Your station's CO or [DN] LED flashes -two pulses in the first second,
then ten pulses in the next second.
+ Hold Recall: other stations' CO or [DN] LEDs that show your station
flash red.
+ Exclusive Hold Recall: other stations with the same line number: steady,
red.
Internal Call-While another station is ringing your station:
+ Your [DN] LED flashes ---ten pulses per second--one second off.
Busy Station Transfer-When an outside call is transferred to your busy
station (from a designated station or Auto Attendant):
+ Your station's CO or [DN] LED flashes -4 pulses per second, 118
second on, 118 second off.
t Other stations' CO or [DN] LEDs that show your station: 314 second on
l/t3 second off-red.
After disconnecting the first call:
4 Your CO or [DN] LED flashes --ten pulses per second.
t Other stations' CO or [DN] LEDs that show your station flash --two
pulses per second.
Alert Signal-When en Alert Signal is sent to your telephone:
t Your ALERT LED lights red for four seconds.
When you send en Alert Signal:
t Your ALERT LED will flash red for 112 second.
w Other stations' CO or [DN] LEDs that show your station: steady, red.
On-hook/Off-hook
Some procedures in this user guide instruct you to perform a step while "on-
hook" or "off-hook." These terms refer to the position of the handset. '"Off-hook"
indicates that the handset should be lifted off of the telephone cradle. "On-hook"
indicates that the handset should remain in the cradle and should not be lifted.
8
9