Toshiba Strata DK 280 Installation Manual page 512

Program 60-2 - 7 -
SMDR Output/Account Code Digit Length
Item
2
3
4
5
SELECT = 2 - 7 (Item) - - For "2" SMDR TIME = 0 or 1
Make a selection to indicate
Enter 0 to indicate 1 second threshold time.
which item is being assigned.
Enter 1 to indicate 10 second threshold time.
For "3" SMDR COR = 0 or 1 (Data)
Enter one digit to indicate SMDR output operation.
0 = No incoming Record
1 = Incoming and Outgoing Record
For "4" ACCOUNT = 04 - 15
Enter the number of digits allowed for Forced/Voluntary
Account Codes. The range is 04 - 15. Enter two digits.
For "5" TOLL DIAL
Enter one digit (the range is 0 - 5).
For "6" DISA SECURITY CODE 01 - 15 DIGITS
For "7" CREDIT CARD DIGITS
Description Data
SMDR Threshold Time'
0 = 1 second 1 = 10 seconds
SMDR
Output when a call is completed.
0 = Outgoing Only
1 = Incoming and Outgoing
TIME
q
(SMDR COR)
q
Forced/Voluntary Account Code Digit Length 04 - 1 54.
(Digits are verified per Prog. 30? Button/LED 14, and Prog. 69)
(ACCOUNT) n n
SMDR Printout options
-
- 10) All Calls'
Toll Dial - _
= 111 Dial "0" calls only
= 2
q
Dial "1" calls only
-
= 131 Dial "00" calls only
=
q
Dial "l", "O", calls only
= 5
q
Dial "1" or "00" calls only
(TOLL DIAL DATA)
q
DISA Security Code" (01 - 15 digits, may be
changed from station, per Program 30)
I
DATA'
q n
Credit card call digit length, 01 - 3O'digits (see Program 43)
I
CREDIT5 ri rl
Notes:
1. Selection 3 (printout outgoing call only) is stilt available.
2. Button 01 = blank: Button 02 is a wild card (can be any digit from 1 - 9).
3: If a security code is not programmed, outgoing trunk access via DlSA will not require a security code when dialing.
4. See Program 69 for Verified Account Codes.
DK0245
5. Number of digits required when "0" is the first digit dialed; if this number of digits is not dialed, the sysfem will disconnect the Cal/ after
20 seconds. "0" is counted as a digit. Example: 0 + 1 + 714 + 583 - 3700 = 12 digits; 72 should be programmed as a minimum in this
case.
6. Default is 10 seconds.
7. Default is 21 -digits.
General Notes:
.
For Selection 3, initialized data assigns SMDR output to be enabled for incoming/outgoing calls that are answered.
.
For Selection 4, initialized data assigns a g-digit length to all Forced/Voluntary Account Codes,
.
If PBX code is dialed, numbers dialed
after
the code will be checked.
.
If AK, O/C or SPCC code begins with "O", "l", or "OOq that call will print out.