Test Mode; Co Line Testing - Toshiba Strata DK 280 Installation Manual

LCD Messages Dump: While in the Dump mode,
enter MSG, three characters, then press Enter. The
characters represent stored messages for either an
individual station port (000 - 239), ALL (all stations
and system data) or S Y S (system data only). For a
printout example, see Figure 13-7.
>MODE DUMP
D MSG SYS
SYS M60 OUT TO LUNCH
SYS M61 IN A MEETING
SYS M62 CALL
SYS M63 BACK AT
SYS M64 RETURN ON
SYS M65
SYS M66
SYS M67
SYS M68
SYS M69
D
Figure 13-7
n
Establish a talk path between the two remote
Sample Printout of System Messages
stations (B & C) via a CO-to-CO connection
through Strata DK.
Tl Error Dump: While in the Dump mode, enter
TlERR; press Enter. A Tl error status will then
appear on the terminal or PC screen.
Data dump tables later in this chapter provide a quick
reference to the step-by-step procedures to output the
appropriate data.
Trace Dump: While in the Dump mode, enter TRC,
then Enter. DK280 data activity will be sent to the
terminal or PC. Trace data is intended to be used for
troubleshooting by trained engineers, only. To stop
Trace,press Delete and Enter.
January 1996
13-13
13.10 Test Mode
The remote test mode can be used to test Strata
DK280 stations and CO line circuits from an off-site
location.
This testing function is accomplished by accessing
stations from the remote terminal, and activating
various buttons on digital and electronic telephones to
make telephone calls, set function buttons, change the
system time and date, etc. (see Figure 13-8).
IMPORTANT!
Any digital or electronic telephone button can
be activated from the remote terminal at any
time while in the Test Mode (even while the
end user is using the telephone). Therefore,
caution must be used to prevent service
interruption or interference. The Test Mode
provides status tests to check whether or not
a station or CO line is in use. The status
checks should always be made before
performing other tests.
13.10.1 CO line Testing
To test CO line transmission, two or three CO lines
must be available at the remote site (see Figure 13-8).
CO line testing is accomplished by using all of the
following three methods:
W Call station B at the remote site via the Strata
DK280 system and then place the line on hold
(transmission is checked at the remote site via
Music-on-Hold).
n
Establish a talk path between a remote station and
the time or weather service via a CO-to-CC
connection through Strata DK.
The procedures in the tables provide examples of the
types of tests and functions that can be accomplished
with the Test Mode. These procedures do not cover all
the possible tests that can be performed remotely;
however, by using the principles given, other tests are
possible.
13.11 LCD Message Mode
This mode allows a local or remote terminal to set
Called and Calling Station LCD messages for station
users. The messages may be system or station type
and are stored in their respective memory locations
when set.