Automatic Callback - Toshiba Strata DK 280 Installation Manual

c
To Change the Destination
Number:
1. Call into the DK280
system over a CO line
programmed for the
Direct inward System
Access (DISA) feature.
2. Listen for the ringback
tone signal, then
internal dial tone.
3. Enter # 6 7 0. then the
Primary Directory
Number of your station.
4. Enter the Remote Call
Forward-External
security code.
5. Enter the new
destination number.
6. pressf#
To Activate/Deactivate Call ,
Forward-Fixed:
?
, Press CFF.
Remote
Call Forward-External Destination Change
If Call Forward-External mode is set at your station, you can change the
forwarding destination from a telephone outside of the system.
Sea the System Administrator for DISA telephone numbers.
Try again if you hear busy tone. Dial tone will be present for tan seconds to allow
direct dialing of '"Change Call Forward" access code plus your Primary Directory
Number. If a number is not dialed, the system automatically causes the DISA CO
line to ring at telephones as a normal incoming call. Then, if the call is not
answered within 15 seconds after the ringing starts, it will disconnect.
You will hear a confirmation tone.
You will hear a confirmation tone after entering the code. See the System
Administrator for the security code which is assigned to your telephone in system
programming.
You may enter an internal number, Voice Mail number or, a CO line access code
plus an external telephone number. With some systems. you can dial a line
group code instead of a CO line number access code. (See Appendix A-Table
1 for access coda information.)
You will hear a confirmation tone.
Call Forward-Fixed
If you activate this feature, all internal and Private or Direct Inward Dialed CO
line calls to your station will forward immediately to a Primary Directory Number
set in system programming. Your station must be assigned with the CFF button
in system programming to activate this feature.
The CFF LED will light steady red and all calls will forward to a station Directory
Number or voice mail device set in system programming. CFF toggles on/off.
To Set AC6 (to busy or
DND station):
1.
2.
3.
4.
5.
After reaching a busy
station, press ACB or 4.
Place the handset on-
hook.
Your telephone will ring
at a fast rate when the
called station becomes
idle.
Answer within three
rings to prevent the
callback from being
cancelled.
Make a voice announce
and converse.
To Cancel AC6 (to busy or
DND station):
N Press a [DN] + # 4 3.
Automatic Callback will be cancelled.
Automatic Callback
After reaching a busy or Do Not Disturb station, you may set Automatic Callback
(ACB) to have the system call you back when the called station becomes
available.
Busy tone will stop momentarily, then you will hear two seconds of dial tone, then
busy tone will resume.
You may make other calls while waiting for the called station to become
available.
The LED will flash at the incoming call rate.
After you answer the ACB ringing, you will hear a single tone, and the LED will
flash at the In-use rate. The called station will receive a voice announce call from
your telephone or. with Tone Signaling, you would hear ringback tone and the
called station would ring.
If you hear a busy tone after answering a callback, the called party has already
received or originated another call. Your request is not cancelled.
32
33