Page Announcements; All Call Page - Toshiba Strata DK 280 Installation Manual

To Make a Page
Announcement:
1. Press a [DN], lift the
handset, and dial one
of the paging access
codes.
Page Announcements
Station users can make page announcements to telephones and external
sueakers.
Notes:
1. See Appendix A-Table Z-Paging Group and Zone Codes.
2. Each of the page access codes (including the [DN] button) can be
stored on an SD button. See Appendix A-Table l-User
Programmable Feature Buttons.
2. Make your
announcement in a
normal voice level and
repeat it.
3.
Hang up when you
complete your
announcement.
All Call Page
You can make an All Call Page to digital and electronic telephones assigned to
the "All Call Page Group." Stations are assigned to the "All Call Page Group" in
system programming.
To Make an All Call Page:
1. Press AC and lift the
handset
- or -
press a [DN] + # 3 9
2. Make your
announcement in a
normal voice level and
repeat it.
3.
Hang up when you
finish your
announcement.
The AC button does not access external page speakers.
Note:
# 3 9 may also Page external speakers, depending on system
programming.
40
Automatic Busy Redial
After reaching a busy outside number, you can activate Automatic Busy Redial
(ABR) so that the Strata DK280 system will automatically radial that number for
you at regular intervals. ABR is an optional feature enabled in system
programming. This feature may not be allowed on some (or all) lines in your
system-depending on the telephone line type connected.
To Activate Automatic Busy
(ABR) Redial:
While listening to busy
tone-
1. Press ABR
-O'-
press CDNFITRNS +
# 4 4.
2. Hang up or press
SPKR.
3. The system will redial
the number.
4. Your telephone will
receive ring tone when
ABR dials the number
and it is available.
5. Lift the handset or
press SPKR button
and wait for the party to
answer.
To Cancel ABR:
N Press ABR.
or -
press [DN] + # 4 4.
41
The ABR LED will flash red.
-O'-
You will hear confirmation tone after you press CDNFITRNS + # 4 4.
Hang up if the call was established off-hook; press SPKR if the call was
established on-hook.
The system will redial every every 30 or 60 seconds (depending on system
programming), up to 15 times (See Notes 1 and 2).
The [DN] or Line and SPKR LEDs will flash. The called telephone number will
ring.
If you do not pick up the handset or press SPKR within 30 seconds after a
connection is made. you will hear a muted ring for another 30 seconds, then the
call will disconnect.
Notes:
1. ABR will not be attempted while your station is busy, but will
continue to time-out.
2. With each attempt:
n The CO and SPKR LEDs blink when the line is seized.
n Dial tone is heard via the speaker.
n The telephone number is redialed.
1 If busy, ABR will reset and fry again.