Toshiba Strata DK 280 Installation Manual page 719

c
To Dial an Outside Number
(Direct Access):
1, Lift the handset or
press SPKR.
2. Press any available
[DN], CO, or PI.
button.
3. Dial a telephone
number.
To Dial an Outside Number
(Access Code):
1.
Lift
the handset.
2. Press a [DN]
3. Dial a CO line access
code.
4. Dial a telephone
number.
Dialing Outside Calls
You can make calls to or receive calls from telephones outside of the Strata
DK280 system.
Direct Dialing
If the [DN], CO, or PL LED lights when you lift the handset, your telephone has
Automatic Off-Hook Selection and you can skip Step 2. If the LED does not light,
follow Steps 2 and 3.
CO and PL buttons access outside CO lines. After selecting a line, you should
hear CO line dial tone and the LED will flash at the In-use rate.
Dial tone stops after the first digit is dialed, but the LED will continue to flash
during the call.
CO Line Access Code Dialing
If the [DN], CO. or PL LED lights when you lift the handset, your telephone is
programmed for Automatic Off-Hook Selection and you can go on to Step 3. If it
doesn't light, follow Steps 2 and 3.
When you lift the handset, you will hear internal dial tone and the LED will flash
at the In-use rate.
You will hear CO line dial tone and the LED continues to flash at the In-use rate.
See Appendix A-Table l-CO Line Access Codes.
Dial tone stops after the first digit is dialed, but the LED will continue to flash at
the In-use rate.
To Dial an Outside Call
While On-hook:
Press any available CO
or PL button
- or.
press [DN] + CO
- or -
press a [DN] and enter
a CO line group access
code.
Dial a telephone
number.
Lift the handset when
the called party
a"SWC?rS.
Hang up or press
SPKR when the call is
To Dial an Internal Call:
1. Lift the handset.
2. With the handset on-
hook press a [DN].
3. Dial a Directory
Number.
On-hook Dialing
You can dial calls without lifting the handset. You must lift the handset to
converse, unless your telephone is a full speakerphone.
You will hear CO line dial tone and the [DN], CO, or PL LED will flash at the In-
use rate.
See Appendix A-Table I-CO Line Access Codes.
You will hear CO line dial tone and the LED continues to flash at the In-use rate.
Dial tone stops after the first digit is dialed, but the LED flashes during the call.
The LED will continue to flash. You do not have to lift the handset if you have a
full speakerphone.
The LED will turn off. Press SPKR to disconnect the call if you did not lift the
handset.
Dialing Internal Calls
You can make calls to and receive calls from other stations in the Strata DK280
system
If you hear CO line dial tone when you lift the handset, then your telephone has
Automatic Off-hook Selection. and you can skip Step 2.
After you press a [DN], you will hear the dial tone and the LED will flash at the
In-use rate.
15