Toshiba Strata DK 280 Installation Manual page 418

Initialization Program 90 -
initializing Programs 00 - *99
Enter programming
mode.
LEnd 7
be initialized.
Press button LEDs 01
Exit
01 and 02, and 02 must Program
LEDs 01 flash. 90.
programming
mode.
and 02 must
be lit.
IMPORTANT!
This Program is primarily used to initialize individual Programs in DK280 software.
To initialize one program at a time, just enter the individual program number, then
#, then Button 0 1 and 02 plus Hold.
Initialize Programs 00 - *99 every time':
l
A new system is installed
l
To bring a system's programming back to the default setting.
Specify the range as follows. -nmmmmm (see CAUTfON! note)
0
-r-l--T-
Low Numbered Program 2 (
L--- High Numbered Program
(For "*"programs, insert the "*"
prior to entering the program
Range Separator
number.)
Note:
7. Running Program 97-9 will run this program to initialize Programs 00 * @9.
General Notes:
l
Always complete Program 90 at new system installs, before programming
anything else. Skipping this step may cause erratic system behavior. If
Program 91-9 is completed, it is not necessary to run Program 90 after running
Program 9 l-9.
l
Follow instructions in Table 8-5 in Chapter 8-Programming Introduction to
c/ear this data.
l
To initialize all programs, a "* #' must be entered between 00 and 99.
l
Each "#'program record sheet immediately follows the program record sheet
having the same number (Example *37 follows 31 record sheet). However in
system memory, all "@programs follow Program 99. Therefore, when
initializing star "g' program ranges, they must be initialized separate/y from
non-star programs unless initializing all system Programs (00 **99). Example,
to initialize Programs 30, *30, 31, *31, and 32, initialize the range (30 * 32),
for Programs 30, 31, 32; and the range ( *30 **31), for Programs *30 and
*31.
CAUTION !
Running this program will erase customer data. If Program 01, 02, or
91 is initialized by running Program 90, calls will be dropped. *
1 o-2
January 1996