Toshiba Strata DK 280 Installation Manual page 453

Program 16 -
Assign CO Line Groups (Dial 9 or 801 - 816)
SELECT = CO Line Group A
Only enter the last two digits of the trunk group (01 2
I
L
Buttons/LEDs
16) to be defined, or enter 00 for Dial 9 group.
Specify which trunks are assigned to the
group by setting LEDs as defined by the table
Press: m to advance or Fl to go back'
below. All LEDs with an "x" should be lit
when finished.
See Note 1 to turn line ranges (ON/OFF).
Check off the CO line range covered by this table.
Copy this page for more trunks
Notes:
DK0114
1. To turn all CO LEDs on or off, after the Line Group is entered, press the
VOW
(all LEDs on) or
VOW
(all LEDs off).
To check a particular CO line, after the Line Group is entered, press and enter the CO line number, then use the #
button to display and advance.
2. To advance the CO line range, press the
Scroll
button beneath the LCD. Press the
Page
button for a lower range.
General Notes:
I
l
Initialized data assigns all CO lines to the Dial 9 group.
.
With DK280 Release 1,2, and 3, RCTU C/D provides 16 CO line Groups, RCTUA, RCTUB, and RCTLJBAIBB provide
8 CO line Groups.
January 1996 10-37