Check Link Status; Save Translations; High And Critical Reliability; All - Avaya MCC1 Installation And Upgrades

Release 9si/10si/Communication Manager 1.x to Communication Manager 2.1
Task list: R9si/10si/Communication Manager 1.x to Communication Manager 2.1

Check link status

Return to Task List
This optional step is to make sure the links are in service before and after the upgrade.
1
Type display communication-interface links
2
Type status link number
3
Write down which links are enabled and in service.
NOTE:
If any links are enabled and out of service, resolve the problem before continuing the
upgrade.
4
Type list signaling group
Note the signaling groups listed by number.
5
For each of the signaling groups listed, type
Return.
6
If any of the links are not up, take the necessary corrective action to restore the link before
continuing with the upgrade.
Return to Task List

Save translations

Return to Task List
NOTE:
Duplicated translations must match exactly or the command fails.

High and Critical Reliability

1
Execute
2
Verify that conditions are normal (this can take as long as 5 to 10 minutes). If the system refuses
to go into a normal condition, refer to the maintenance procedures; if that fails, escalate the
problem.

All

1
Ensure that the translation card (ATA) is in the TN2401 (Netcon/Pkt Intf) circuit pack's card slot.
2
Type save translation
flashcard (about 10 minutes).
The screen goes blank. This is normal.
NOTE:
Do not press any keyboard key until after the system displays the status (success or
failure) message. If you press Return again, you will not see the status message.
48
and press Enter for each enabled link.
and press Return.
status system 1 before you save translations.
and press Return to write all translations from memory to the translation
and press Enter. Write down all enabled links.
status signaling group <number>
SI Installation and Upgrades
and press
June 2004