Manually Power Up Audix System; Access The System; Task List: Access The System; Task List: Make Data Module Settings - Avaya MCC1 Installation And Upgrades

Bring the System Online

Access the System

Manually Power Up AUDIX System

1
Using a pointed object such as a paper clip or a pen (do not use a pencil), press the
Boot/Shutdown button.
2
Hold the Boot/Shutdown button in until the display indicates the message,
3
Release the Boot/Shutdown button. The DEFINITY AUDIX System takes approximately five
minutes to power up.
— The display has the following sequence of steady on messages:
— The DEFINITY AUDIX System is now powered up. When the system is in the active
state, the display indicates
NOTE:
Upon the system powering up, the DEFINITY AUDIX System automatically reboots.
This sequence may show an
powered up. When the system has completed its power up sequence, the DEFINITY
AUDIX System display reads:
Access the System
Return to Task List
To access the system, you first install Avaya Site Administration software on the PC and then connect to
the Avaya Media Gateway. Select the correct procedures for this installation from the task lists.

Task List: Access the system

•
Install and Use Avaya Site Administration
•
Connect Directly to the Avaya Media Gateway
•
Connect Remotely to the Avaya Media Gateway Through a Data Module
•
Connect Remotely to the Avaya Media Gateway Through a Modem

Task List: Make Data Module Settings

1
Set the Data Module to DCE Mode on page 458
2
Add a Data Module to the Switch on page 458
3
Test Data Module Hardware Connections
452
•
OSINIT
•
OS
•
AINIT
•
ADX
, and the red LED is off.
ADX
MD
or alarm in the display until the system has
MJ ADX
.
ADX
on page 453
on page 454
if necessary
on page 459
SI Installation and Upgrades
, steady on.
BTEST
on page 455
on page 456
June 2004