Troubleshooting
To determine ESM link status enter the following commands from the system administration terminal:
1
Status esm
2
Status signaling-group
3
List MMI
NOTE:
When you move ESM circuit packs, you MUST remove the DS1 and signaling group
translations. You cannot use the change circuit pack command.
Refer to
Expansion services module
Printers
This section provides information on connecting and configuring printers that work with your system and
Avaya™ Communication Manager.
Connecting printers using TCP/IP
Printers can be connected to the switch using asynchronous TCP/IP links and a terminal server. This
section provides information on connecting adjuncts to the C-LAN and providing the initial
administration.
Task list
Whether you use an end-to-end TCP/IP configuration, a terminal server or a PC running RSP, you must
complete the following tasks:
•
Administering IP node names
•
Administering IP services
•
Administering adjunct parameters
•
If you are using a terminal server, also complete
on page 794.
•
If you are using a PC with the Downloadable RSP Tool, complete
reliable session-layer protocol (RSP) tool
Administering adjunct parameters
You must administer adjunct parameters to let the system know that the adjunct is connected through
TCP/IP.
PMS journal and PMS log printers
See Guestworks ® and DEFINITY ® Systems Technician Handbook for Hospitality Installations (555-
231-743).
SI Installation and Upgrades
June 2004
on page 813 for further information.
on page 803.
on page 803.
on page 815.
Installing and administering the terminal server
on page 816.
Adjuncts and Peripherals
Printers
Using the downloadable
815