Rerecord Announcements [From G3V4]; Save Announcements And Translation; Or Tn750B Only) [From G3V4] - Avaya MCC1 Installation And Upgrades

G3iV4 to Avaya Communication Manager
Task List: G3iV4 to Avaya Communication Manager

Rerecord announcements [from G3V4]

Return to Task List
If you have not saved and restored announcements during the upgrade, the customer must re-record all
announcements now.
If the customer changed any announcements after the they provided the source tape for the blowback
flash card, the customer must re-record the new announcements.
Return to Task List
Save announcements and translation (TN750

or TN750B only) [from G3V4]

Return to Task List
1
Remove the original translation card(s) from the TN2401 NetPkt circuit pack(s). These cards are
read-only in the new TN2401.
2
Insert the new translation card(s) into the TN2401 NetPkt circuit pack(s).
3
Type
save announcements
NOTE:
Use this step only for systems equipped with the TN750 or TN750B announcement circuit
pack. Skip this step for systems equipped with the TN750C or TN2501AP integrated
announcement circuit packs, which contain on-board, nonvolatile memory.
This takes about 45 minutes.
4
Type
save translation
This takes about 20 minutes.
NOTE:
Do not press any keyboard key until after the terminal displays the success message. For
example, if you press Enter more than once after typing the command, the second Enter
erases the screen and you never see the success message.
5
If the
save translation
screen and escalate the problem immediately.
Keep the translation media in a safe and secure place.
Return to Task List
92
and press Enter.
and press Enter.
command fails, do not continue. Record the error code that appears on the
SI Installation and Upgrades
June 2004