Install Fiber Optic Cable Pass-Thru Kit
for
SCC1 (Single-Carrier) Cabinets
This section details the installation of the fiber optic pass-thru kit for the SCC1 (Single-Carrier) cabinet
only. This kit provides the equipment necessary to install the fiber optic connectors and associated
cabling.
Install the fiber optic cable pass-thru kit (SCC1)
Use this task list to install the fiber optic cable in the SCC1 (Single-Carrier) cabinet:
1
Prepare the cabinet
2
Install the Fiber-optic Cable with the Pass-thru Kit
systems
3
Test the Installation
LASER Product
CLASS 1 LASER PRODUCT
IEC 825 1993
The Avaya Media Gateway may contain a Class 1 LASER device if single-mode fiber optic cable is
connected to a remote Expansion Port Network (EPN). The LASER device operates within the following
parameters:
•
Maximum Power Output: -5dBm
•
Wavelength: 1310 nm
•
Mode Field Diameter: 8.8 microns
CAUTION:
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Contact your Avaya representative for more information.
SI Installation and Upgrades
June 2004
Install Fiber Optic Cable Pass-Thru Kit for SCC1 (Single-Carrier) Cabinets
Install the fiber optic cable pass-thru kit (SCC1)
or
Install fiber optic cable for duplicated SCC1
193