New Or Upgraded G3Si Only; Direct Connection Between The Switch And Rfa; No Connection Between The Switch And Rfa - Avaya MCC1 Installation And Upgrades

G3iV4 to Avaya Communication Manager
Task List: G3iV4 to Avaya Communication Manager
4
Type
set time
Ensure that the system date and time are set correctly.
5
Use one of these installation methods:
—

Direct connection between the switch and RFA

—

No connection between the switch and RFA

New or upgraded G3si only

1
Retrieve the RFA License File with both serial numbers from the RFA Application.
2
If the system has IP endpoints registered, unplug the Ethernet cable from the TN799 (C-LAN)
circuit pack.
This disconnects (unregisters) all IP endpoints.
3
Type set time
Ensure that the system date and time are set correctly.
4
For duplicated systems only type
Ensure that the standby SPE is not in the maintenance state. If it is, wait for the maintenance state
to finish.
5
Use one of these installation methods:
— Direct connection between the switch and RFA
— No connection between the switch and RFA
Direct connection between the switch and RFA
a
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi"
chapter of the RFA Job Aid, deliver the License File.
NOTE:
This procedure sends the License File to the switch and installs it.
b
If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
No connection between the switch and RFA
a
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi"
chapter of the RFA Job Aid, deliver the License File to your laptop/PC.
b
Open the License Installation Tool (LIT) application at your laptop/PC.
c
Use the LIT instructions to add a switch connection profile to the tool.
d
Use the LIT instructions to install the License File on the switch.
e
If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
84
and press Enter.
and press Enter.
status system all
and press Enter.
SI Installation and Upgrades
June 2004