Upgrade Software; Standard Reliability; High And Critical Reliability - Avaya MCC1 Installation And Upgrades

Upgrade software

Return to Task List

Standard Reliability

1
Insert the 48MB, PCMCIA (orange) card in the TN2404 (Netcon/Pkt Intf) circuit pack's slot.
2
Type
upgrade software
Do not press Return again.
3
When the system beeps, it is prompting you to put the original translation card in the TN2404
(Netcon/Pkt Intf) circuit pack's slot.
NOTE:
You have 2 minutes to replace the software card with the translation card. If you miss this
window, the system comes up without translations. Correct this by inserting the original
translation card into the TN2404 (Netcon/Pkt Intf) circuit pack's slot and use the
system 3

High and Critical Reliability

1
Insert the 48MB PCMCIA (orange) card in the standby SPE.
2
Type upgrade software
3
Do not press Return again.
4
When the SAT beeps, it is prompting you to put the original translation card in the standby SPE.
a
Remove the orange card and replace it with the translation card.
b
Remove the translation card from the active (other) SPE.
c
Insert the 48MB PCMCIA (orange) card into the other SPE.
NOTE:
You have 2 minutes to complete the preceding steps. If you miss this window, the upgrade
aborts, and you must begin again with Step 1 in this section.
SPE interchange occurs (active and standby sides swap roles) and the new software is
present on the active SPE.
5
When the SAT beeps, remove the orange card and replace it with the translation card.
NOTE:
You have 2 minutes to replace the software card with the translation card. If you miss this
window, no corrective action is necessary. Wait until the system is able to achieve
active/standby state.
6
At the login prompt, log into the switch as craft.
Return to Task List
SI Installation and Upgrades
June 2004
Release 9si/10si/Communication Manager 1.x to Communication Manager 2.1
Task list: R9si/10si/Communication Manager 1.x to Communication Manager 2.1
and press Return to upgrade the system software.
command at the SAT.
and press Return to upgrade the system software.
reset
51