Install And Connect Mcc1; (Multicarrier) Cabinet; Task List: Install And Connect Mcc1 - Avaya MCC1 Installation And Upgrades

Install and Connect MCC1

(Multicarrier) Cabinet

This section describes how to install the MCC1 (Multicarrier) cabinet. For information on Single-Carrier
Cabinets, go to
Floor plans and equipment layouts for typical system installations are provided in the Hardware Guide
for Avaya Communication Manager (555-245-207) book.
NOTE:
Before you begin the cabinet installation, check the location of the AC/DC power
receptacles. The receptacles must be on separately fused circuits not controlled by wall
switches. They must be located within 10 feet (3 meters) of the cabinet, and outside the
Main Distribution Frame (MDF) area.

Task List: Install and Connect MCC1

Perform these tasks before you begin the installation:
1
Check Customer's Order
2
Unpack and Inspect Cabinets
3
Unpack and Inspect Auxiliary Cabinet
4
If you cannot get timing from the service provider, you may need to install a Stratum 3 clock. If
this system includes a Stratum 3 clock, go to
5
Check Circuit Packs
6
Correct Shipping Errors
Perform these tasks to install the cabinets:
7
Position the PPN Cabinet
8
Position the EPN Cabinets
9
Position the Auxiliary Cabinet (Optional)
10
If required,
!
If the approved ground or approved floor ground can only be accessed inside a dedicated
power equipment room, then connections to this ground should be made by a licensed
electrician. See
11
Connect AC Power and Ground
task lists.)
12
Connect Remote Power Off Cable
SI Installation and Upgrades
June 2004
Install and Connect SCC1 (Single-Carrier
Install Earthquake Protection for MCC1
WARNING:
Approved Grounds
or Connect DC Power and Ground
Install and Connect MCC1 (Multicarrier) Cabinet
Task List: Install and Connect MCC1
Cabinets).
Installing the Stratum 3 Clock
and Install Auxiliary Cabinet Equipment
for more information.
(These tasks have their own
for instructions.
327