Connect Time Division Multiplexing Bus Cables
Return to Task List
If the cabinet stack contains only one Single-Carrier Cabinet, skip this task.
Locate the white fabric-covered Time Division Multiplexing (TDM) bus cable on the rear of the cabinets.
Use the procedures that apply to this installation:
•
Standard Reliability PPN - One Cabinet Stack
•
High or Critical Reliability PPN - Two Cabinet Stack
•
High or Critical Reliability PPN - Three Cabinet Stack
•
Expansion Port Network (All Reliability Options)
Standard Reliability PPN - One Cabinet Stack
Return to Task List
1
Remove the Time Division Multiplexing (TDM) Bus Terminator (AHF110) from Slot 18 of the
Control Cabinet (Processor Port Network (PPN)) and move it to Slot 17 on the top Port Cabinet.
See
Figure 120, Connections for Standard Reliability Systems,
2
Connect the supplied Time Division Multiplexing (TDM) Bus Cables
(WP-91716 L3) as shown in
SI Installation and Upgrades
June 2004
Install and Connect SCC1 (Single-Carrier Cabinets)
Connect Time Division Multiplexing Bus Cables
on page 385
on page 386
on page 388
on page 389
Figure
120.
on page 386.
385