Polycom RealPresence 800s Administrator's Manual page 659

RealPresence Collaboration Server (RMX) 800s/Virtual Edition Administrator's Guide
Active Alarms
Alarm Code
Hot Backup: Master-Slave
configuration conflict.
Hot backup: Network issue
Hot Backup: Paired MCU is
unreachable.
Initialization of ice stack failed
Insufficient resources
Insufficient UDP Ports
Internal System configuration during
startup
Invalid System Configuration
IP addresses of Signaling Host and
Control Unit are the same
IP Network Service added
IP Network Service configuration
modified
IP Network Service deleted
IP Network Service not found
IPMC software upgrade in component
IPS 140 test result not received
LDAP TLS: Failed to connect to OSCP
responder
Polycom®, Inc.
Alarm Description
Possible reasons:
• When both the MCUs are configured as Master or as Slave
• The slave Collaboration Server is defined with the same IP as the
Master.
The number of resources in the license is higher than the actual system
resources.
Check to make sure sufficient CPU cores are allocated in the Virtual
Machine.
When defining fixed port, the number of defined UDP ports is lower than
the required ports.
Configure additional ports.
System configuration during startup.
Wait until Collaboration Server startup is completed.
IP addresses of Signaling Host and Control Unit are identical.
Assign different IP addresses to the Signaling Host and Control Unit.
IP Network Service was modified.
Reset the MCU.
IP Network Service was deleted.
Reset the MCU.
IP Service not found in the Network Services list.
Configure the IP Network Service.
673