Reverting To A Default Snmp Community String; Deleting A Fabric - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

18. Click OK on the Discover Setup dialog box.

Reverting to a default SNMP community string

1. Select Discover > Setup.
2. Select an IP address from the Available Addresses table.
3. Click Edit.
4. Click the SNMP tab.
5. Click Default 'public' and Default 'private.'
6. Click OK on the Address Properties dialog box.
7.

Deleting a fabric

If you decide you no longer want the Management application to discover and monitor a specific
fabric, you can delete it. Deleting a fabric also deletes the fabric data on the server (both system
collected and user-defined data) except for user-assigned names for the device port, device node,
and device enclosure information.
To delete a fabric, complete the following steps.
1. Select Discovery > Setup.
2. Select the fabric for which you want to delete from the Discovered Addresses table.
3. Click Delete.
DCFM Enterprise User Manual
53-1001775-01
a. Select the Select check box for each undiscovered seed switch to discover their fabrics.
b. Click OK on the Undiscovered Seed Switches dialog box.
The Discover Setup dialog box displays.
The Address Properties dialog box displays.
Click OK on the Discover Setup dialog box.
The Discover Setup dialog box displays.
You are prompted to confirm that you want to delete the fabric.
Reverting to a default SNMP community string
2
41