Creating A New Member In A Zone By Wwn - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

22

Creating a new member in a zone by WWN

5. Select an option from the Type list.
6. Select one or more members to add to the zone in the Potential Members list. (Press SHIFT or
7.
8. For offline zone databases only, complete the following steps to save the zone configuration
9. Click OK or Apply to save your changes.
Creating a new member in a zone by WWN
Use this procedure to add a member to a zone when the member is not listed in the Potential
Members list of the Zone DB tab.
For instructions to add a member to a zone when the member is listed in the Potential Members
list, refer to the procedure
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Select one or more zones to which you want to add members in the Zones list. (Press SHIFT or
610
By default, the first time you launch the Zoning dialog box for a Zoning Scope, the Potential
Members list displays valid members using the following rules:
•
If you select the World Wide Name type, the valid members display by the Attached Ports.
•
If you select the Domain/Port Index type, the valid members display by the ALL Product
Ports (both occupied and unoccupied). This option is available for FC fabrics only.
•
If you select the Alias type, the valid members display by the device Alias.
CTRL and click each member to select more than one member. To add all ports on a device,
select the device.)
Click the right arrow between the Potential Members list and Zones list to add the selected
members to the zone.
A message may display informing you that one or some of the selected potential members
cannot be zoned. Click OK to close the message box. Reconsider your selections and make
corrections as appropriate.
into the switch from the offline zone database:
a. Select Save to Switch from the Zone DB Operation list.
b. Click Yes on the confirmation message.
The selected zone database is saved to the fabric without enabling a specific zone
configuration.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.
"Adding members to a zone"
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
CTRL and click each zone name to select more than one zone.)
on page 609.
DCFM Enterprise User Manual
53-1001775-01