Selecting A Zoning View; Creating And Populating Zone Aliases - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

To save the local zone changes, perform the following steps.
1. Make the zoning changes in the Zone Administration window.
2. Select Zoning Actions > Save Config.
NOTE
If you have made changes to a configuration, you must enable the configuration before the changes
are effective. To enable the configuration, refer to

Selecting a zoning view

You can define how zoning elements are displayed in the Zone Administration window. The zoning
view you select determines how members are displayed in the Member Selection List panel
(Figure
List for the selected view, making it easier for you to create and modify zones, especially when
creating "hard zones."
Depending on the method you use to zone, certain tabs might or might not be available in the Zone
Administration window.
There are two views of defining members for zoning:
•
•
To define the view of the fabric resource, perform the following steps.
1. Launch the Zone Administration window as described in
2. Select View > Choose Fabric Resources View.
3. Define the way you want to view the fabric resource and click OK.

Creating and populating zone aliases

An alias is a logical group of port index numbers and WWNs. Specifying groups of ports or devices
as an alias makes zone configuration easier, by enabling you to configure zones using an alias
rather than providing a long string of individual members. You can specify members of an alias
using the following methods:
•
•
For more information on enabling the configuration, refer to
page 118.
To create a zone alias, perform the following steps.
Web Tools Administrator's Guide
53-1002756-01
24). The views filter the fabric and device information displayed in the Member Selection
Fabric View—Displays the physical hierarchy of the fabric, a list of the attached and imported
physical devices (by WWN), and a list of the FC Virtual Initiators on switches that support iSCSI.
In the Fabric View, you can select ports for port-based zoning or devices for WWN-based
zoning.
Devices Only—Displays a list of the attached and imported physical devices by WWN. You
cannot select ports for port-based or mixed zoning schemes, nor can you select virtual
initiators for iSCSI FC Zone creation.
page 104.
Identifying members by switch domain and port index number pair, for example, 2, 20.
Identifying members by device node and device port WWNs.
Zoning management
"Enabling zone configurations"
"Opening the Zone Admin window"
"Enabling zone configurations"
8
on page 118.
on
on
109