Fcoe - Brocade Communications Systems Brocade 8/12c Command Reference Manual

FCoE

Manages and displays FCoE configuration.
Synopsis fcoe --cfgshow [[slot]port]
fcoe --disable [slot]port
fcoe --enable [slot]port
fcoe --loginshow [[slot]port]
fcoe --fcmapset -vlan vid fcmapid
fcoe --fcmapunset -vlan vid
fcoe --fipcfg -advintvl intvl
fcoe --fipcfgshow
fcoe --resetlogin [-teport slot/port | -device wwn ]
fcoe --help
Description Use this command to configure and display the status of FCoE ports, FCoE Initialization Protocol
(FIP), and FCMAP settings.
Unlike regular FC ports, FCoE ports are embedded interfaces that are not directly associated with
an external physical port on the switch. Although show commands such as switchShow display
FCoE ports as "ports," configuration of these ports through the regular FC CLI is disabled. Only the
FCoE CLI commands can be used.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands.
slot
port
--help
--cfgshow
--disable
--enable
--loginshow
--fcmapset
Fabric OS Command Reference
53-1001764-01
Specifies the slot number on bladed systems, followed by a slash (/).
Specifies the port number. There are 24 configurable embedded FCoE ports
on the Brocade 8000 switch, and the valid range for port is 8 to 31. On the
Brocade FCoE 10-24 blade, there are 24 configurable FCoE ports numbered
0-23. Use switchShow for a list of valid FCoE ports.
Displays the command usage.
Displays the configuration of a specified embedded FCoE port. If a port is not
specified, the command displays all port configurations.
Disables the specified FCoE port.
Enables the specified FCoE port.
Displays information about the devices logged into the specified FCoE port.
Configures the FCMAP values for Fabric Provided MAC Addresses (FPMA) for
the specified VLANs.
-vlan vid Specifies the VLAN for which to set the FCMAP.
fcmapid Specifies the FCMAP to be set.
2
FCoE
255