Brocade Communications Systems Brocade 8/12c Command Reference Manual page 24

•
•
•
FCR
•
•
FICON
•
•
•
FCIP
The portCfg, portCfgShow, portShow, and portCmd help pages have been updated with the following
information:
•
•
•
•
•
•
•
•
•
xxiv
fwMailcfg - Support for multiple e-mails (up to 5).
thConfig - New operand -sfptype to support SFP monitoring.
Ability to interrupt and restart Fabric Watch monitoring:
-
portThConfig --pause | --continue
-
sysMonitor --pause | --continue
-
thConfig --pause | --continuue
Support for removal of stale translate domains in edge fabrics without disruption.
-
fcrXlateConfig --show stalexd
-
fcrXlateConfig --delete stalexd
portCfgShow/portShow - Display of FEC status (on/off)
ficonCfg - Accepts both hex and decimal numbers for the port argument
ficonShow - Displays both hex and decimal numbers for the port argument
ficonCupSet - Modified as follows:
-
Port names are truncated to 24 characters when you enable fmsmode.
-
Need to wait after issuing switchEnable until all ports are up before enabling fmsmode.
The Brocade FR4-18i and FX8-24 blades cannot co-exist in the same chassis.
Commands valid only on the Brocade 7500/7500E are no longer supported.
FC fastwrite and Byte streaming on FCIP tunnels are no longer supported.
IPv6 addresses are supported except for inband management interfaces.
The restrictions on addressing have been lifted. An IPv4 subnet can span multiple GbE interfaces,
and you can now have multiple IPv6 addresses with the same prefix configured on different GbE
interfaces on the same extension switch or blade.
Support for lossless failover on non-local XGE crossport: new -x | --crossport operand to portCfg
ipif/iproute, portShow, and portCmd (Brocade FX8-24/7800 only).
portCfg mgmtif, portCfg mgmtroute - Support for inband management (Brocade FX8-24/7800
only.
portShow mgmtif, portShow mgmtroute - Support for inband management (Brocade
FX8-24/7800 only.
portCfg fciptunel enhancements:
-
the maximum comm._rate has increased to 10,000,000 for 10G ports.
-
New compression mode 4 (Auto compression) automatically adjusts compression level based
on the maximum configured tunnel bandwidth.
-
New -l | --legacy option allows connection to IPSec-configured tunnels that use pre-Fabric
-
new FICON options to support Teradata server (--ficon-tera-read and --ficon-tera-write)
-
New optional circuit argument -C | --connection-type specifies whether the circuit is the
listener or the initiator.
-
-q | --qos - Enhanced to configure QoS high, medium, low values as percentages.
Fabric OS Command Reference
53-1002147-01