24
Displaying RIP filters
The commands apply route map map1 as route filters to routes learned from the RIP neighbor on
port 1/2.
Setting RIP timers
You can set basic update timers for the RIP protocol. The protocol must be enabled in order to set
the timers.
To set the timers.
BigIron RX(config) router rip
BigIron RX(config-rip-router)# timers 50
Syntax: [no] timers <seconds>
Possible values: 3 - 21845 seconds
Default: 30 seconds
The command specifies how often RIP update messages are sent.
Displaying RIP filters
To display RIP filters, enter the following command at any CLI level.
BigIron RX> show ip rip
RIP Summary
Default port 520
Static Metric : 1
OSPF Metric : 1
Syntax: show ip rip
This display shows the following information.
TABLE 104
This field...
RIP Summary area
Statis metric
672
Administrative distance is 120
updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Last broadcast 30, Next Update 29
Need trigger update 0, next trigger broadcast 1
Minimum update interval 25, Max update offset 5
Split horizon is on; poison reverse is off
import metric 1
Default routes are accepted
Prefix List, Inbound, Not set
Prefix List, Outbound, Not set
Redistribute: CONNECTED
Routemap : map1
Routemap
RIP Neighbor Filter Table
Index
Action
Neighbor IP Address
1
permit
any
CLI display of neighbor filter information
Metric : 0
Routemap : Not Set
.not defined.
: Not Set
Displays...
Shows the current configuration of RIP on the device.
Shows the static metric configuration. ".not defined" means the route
map has not been distributed.
BigIron RX Series Configuration Guide
53-1001810-01