Cli Example For Figure 30; Other Vlan Features; Allocating Memory For More Vlans Or Virtual Routing Interfaces311; Hardware Flooding For Layer 2 Multicast And Broadcast Packets311 - Dell PowerConnect B-RX Configuration Manual

CLI example for
To configure the private VLANs shown in
BigIron RX(config)# vlan 901
BigIron RX(config-vlan-901)# untagged ethernet 3/5 to 3/6
BigIron RX(config-vlan-901)# pvlan type community
BigIron RX(config-vlan-901)# exit
BigIron RX(config)# vlan 902
BigIron RX(config-vlan-902)# untagged ethernet 3/9 to 3/10
BigIron RX(config-vlan-902)# pvlan type isolated
BigIron RX(config-vlan-902)# exit
BigIron RX(config)# vlan 903
BigIron RX(config-vlan-903)# untagged ethernet 3/5 to 3/6
BigIron RX(config-vlan-903)# pvlan type community
BigIron RX(config-vlan-903)# exit
BigIron RX(config)# vlan 7
BigIron RX(config-vlan-7)# untagged ethernet 3/2
BigIron RX(config-vlan-7)# pvlan type primary
BigIron RX(config-vlan-7)# pvlan mapping 901 ethernet 3/2
BigIron RX(config-vlan-7)# pvlan mapping 902 ethernet 3/2
BigIron RX(config-vlan-7)# pvlan mapping 903 ethernet 3/2

Other VLAN features

Allocating memory for more VLANs or virtual routing interfaces
By default, you can configure up to 512 VLANs and virtual routing interfaces on the device.
Although this is the default maximum, the device can support up to 4089 VLANs and 4095 virtual
routing interfaces. (VLAN IDs 0, 4090, 4091, 4092 and 4095 are reserved.)
NOTE
If many of your VLANs will have an identical configuration, you might want to configure VLAN groups.
If you need to configure more than 512 VLANs, enter commands such as the following at the global
CONFIG level of the CLI.
BigIron RX(config)# system-max vlan 2048
BigIron RX(config)# write memory
BigIron RX(config)# end
BigIron RX# reload
Syntax: [no] system-max vlan <num>
The <num> parameter specifies the maximum number of VLANs that can be configured. Enter 1 –
4089, but IDs 4091 – 4094 are reserved.
Hardware flooding for Layer 2 multicast and broadcast packets
Broadcast and multicast packets do not have a specific recipient. In order for these "special"
packets to reach their intended recipient, they needed to be sent on all ports of the VLAN (or
"flooded" across the VLAN).
BigIron RX Series Configuration Guide
53-1001810-01
Figure 30
Figure 30

Other VLAN features

on page 306, enter the following commands.
11
311