Strictly Or Explicitly Tagging A Port; Assigning Or Changing A Vlan Priority - Dell PowerConnect B-RX Configuration Manual

11
Configuring port-based VLANs
On a given packet processor (PPCR), the total of:
TABLE 62
.
Module type
24 x 1G
Clearing counters
To clear the byte counter for a VLAN, enter a command such as the following.
BigIron RX(config) #clear vlan byte-accounting 10
You can also enter the following command to clear the byte counter for all VLANs.
BigIron RX(config) #clear vlan byte-accounting all-vlans
Syntax: clear vlan byte-accounting <vlan-id> | all-vlans
Enter a VLAN ID if you want to clear the byte counters for a specific VLAN. Enter all-vlans to clear the
byte counters for all VLANs.

Strictly or explicitly tagging a port

If you want a port to be strictly or explicitly tagged, that port has to be removed from the default
VLAN. Enter a command such as the following.
BigIron RX(config)# vlan 2
BigIron RX(config-vlan-2)# tagged e 1/1 to 1/8
BigIron RX(config-vlan-2)# vlan 1
BigIron RX(config-vlan-1)# no untagged e 1/1 to 1/8

Assigning or changing a VLAN priority

You can prioritize traffic on a VLAN by assigning a priority to a VLAN. All packets associated with the
VLAN will be classified to the configured priority.
BigIron RX(config-vlan-2)# priority 2
Syntax: [no] priority <num>
Possible Values: 0 - 7, "0" assigns the lowest priority and "7", the highest priority. The default is "0".
286
Number of VLANs with byte accounting enabled
+
Number of rate limiting policies based on ACLs and VLANs
cannot exceed the maximum number of policies as specified in
Maximum # of rate limiting policies and VLANs w/ byte accounting permitted per-PPCR
PPCR number
PPCR 1
PPCR 2
Port # Max # of rate limiting policies based on ACLs and VLANs + number of
VLANs w/ byte accounting enabled
1 - 12 115
13 - 24 115
Table 62.
BigIron RX Series Configuration Guide
53-1001810-01