Displaying Summary Information - Dell PowerConnect B-RX Configuration Manual

23
Configuring MSDP mesh groups

Displaying summary information

To display summary MSDP information, enter the following command at any level of the CLI.
BigIron RX# show ip msdp summary
MSDP Peer Status Summary
KA: Keepalive SA:Source-Active NOT: Notification
Peer Address
206.251.17.30
206.251.17.41
Syntax: show ip msdp summary
This display shows the following information.
TABLE 101
This field...
Peer Address
State
KA In
KA Out
SA In
SA Out
NOT In
NOT Out
638
State
In
ESTABLISH 3
ESTABLISH 0
MSDP summary information
Displays...
The IP address of the peer's interface with the device
The state of the MSDP router's connection with the peer. The state can
be one of the following:
•
•
•
•
The number of MSDP Keepalive messages the MSDP router has
received from the peer
The number of MSDP Keepalive messages the MSDP router has sent to
the peer
The number of Source Active messages the MSDP router has received
from the peer
The number of Source Active messages the MSDP router has sent to the
peer
The number of Notification messages the MSDP router has received
from the peer
The number of Notification messages the MSDP router has sent to the
peer
KA SA
Out In Out
3 0 640
3 651 0
CONNECTING – The session is in the active open state.
ESTABLISHED – The MSDP session is fully up.
INACTIVE – The session is idle.
LISTENING – The session is in the passive open state.
NOT
In Out
0 0
0 0
BigIron RX Series Configuration Guide
53-1001810-01