Dell PowerConnect B-RX Configuration Manual page 656

23
IGMP v3
This field
Mode
#_src
Group
Displaying the IGMP status of an interface
You can display the status of a multicast enabled port by entering a command such as the
following.
BigIron RX# show ip igmp interface
query interval = 60, max response time= 3, group membership time=140
v5: default V2,
e4/12
v18: default V2,
e4/20
v20: configured V3,
v110: configured V3,
e4/6
e4/5
Syntax: show ip igmp interface [ve | ethernet <number> <group-address>]
Enter ve and its <number> or ethernet and its <number> to display information for a specific
virtual routing interface or ethernet interface.
Entering an address for <group-address> displays information for a specified group on the
specified interface.
The report shows the following information.
This field
Query interval
Max response
584
PIM dense, addr=1.1.1.2
has 0 groups, non-Querier (age=40), default V2
DVMRP, addr=2.2.2.1
has 0 groups, Querier, default V2
PIM dense (port down), addr=1.1.20.1
PIM dense, addr=110.110.110.1
has 2 groups, Querier, default V3
group: 239.0.0.1, exclude, life=100, deny 13
group: 224.1.10.1, include, permit 2
has 3 groups, Querier, default V3
group: 224.2.2.2, include, permit 100
group: 239.0.0.1, include, permit 10
group: 224.1.10.1, include, permit 1
Table 0.1:
Displays
Indicates current mode of the interface: Include or Exclude. If the interface is
in Include mode, it admits traffic only from the source list. If an interface is in
Exclude mode, it denies traffic from the source list and accepts the rest.
Identifies the source list that will be included or excluded on the interface.
If IGMP V2 group is in Exclude mode with a #_src of 0, the group excludes
traffic from 0 (zero) source list, which means that all traffic sources are
included.
If you requested a detailed report, the following information is displayed:
•
The multicast group address
•
The mode of the group
•
A list of sources from which traffic will be admitted (include) or denied
(exclude) on the interface is listed.
•
The life of each source list.
If you requested a tracking report, the clients from which reports were
received are identified.
Table 0.2:
Displays
Displays how often a querier sends a general query on the interface.
The maximum number of seconds a client can wait before it replies to the
query.
BigIron RX Series Configuration Guide
53-1001810-01