•
For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the stack/slot/port information.
VLAN ID: Identification number of the Control VLAN.
4
Configure a Transit node.
CONFIG-FRRP mode.
mode transit
5
Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring's Member VLANs.
6
Enable this FRRP group on this switch.
CONFIG-FRRP mode.
no disable
Setting the FRRP Timers
To set the FRRP timers, use the following command.
NOTE:
Set the Dead-Interval time 3 times the Hello-Interval.
•
Enter the desired intervals for Hello-Interval or Dead-Interval times.
CONFIG-FRRP mode.
timer {hello-interval|dead-interval} milliseconds
•
Hello-Interval: the range is from 50 to 2000, in increments of 50 (default is 500).
•
Dead-Interval: the range is from 50 to 6000, in increments of 50 (default is 1500).
Clearing the FRRP Counters
To clear the FRRP counters, use one of the following commands.
•
Clear the counters associated with this Ring ID.
EXEC PRIVELEGED mode.
clear frrp ring-id
Ring ID: the range is from 1 to 255.
•
Clear the counters associated with all FRRP groups.
EXEC PRIVELEGED mode.
clear frrp
Viewing the FRRP Configuration
To view the configuration for the FRRP group, use the following command.
•
Show the configuration for this FRRP group.
Force10 Resilient Ring Protocol (FRRP)
343