Setting The Frrp Timers; Clearing The Frrp Counters; Viewing The Frrp Configuration; Viewing The Frrp Information - Dell Z9000 Configuration Manual

5. Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring's Member VLANs.
6. Enable this FRRP group on this switch.
CONFIG-FRRP mode.
no disable

Setting the FRRP Timers

To set the FRRP timers, use the following command.
NOTE: Set the Dead-Interval time 3 times the Hello-Interval.
• Enter the desired intervals for Hello-Interval or Dead-Interval times.
CONFIG-FRRP mode.
timer {hello-interval|dead-interval} milliseconds
– Hello-Interval: the range is from 50 to 2000, in increments of 50 (default is 500).
– Dead-Interval: the range is from 50 to 6000, in increments of 50 (default is 1500).

Clearing the FRRP Counters

To clear the FRRP counters, use one of the following commands.
• Clear the counters associated with this Ring ID.
EXEC PRIVELEGED mode.
clear frrp ring-id
Ring ID: the range is from 1 to 255.
• Clear the counters associated with all FRRP groups.
EXEC PRIVELEGED mode.
clear frrp

Viewing the FRRP Configuration

To view the configuration for the FRRP group, use the following command.
• Show the configuration for this FRRP group.
CONFIG-FRRP mode.
show configuration

Viewing the FRRP Information

To view general FRRP information, use one of the following commands.
Force10 Resilient Ring Protocol (FRRP)
289