Dell PowerConnect B-RX Configuration Manual page 1050

33
Displaying 802.1x information
Displaying information about the dot1x-mac-sessions on each port
To display information about the dot1x-mac-sessions on each port on the device, enter the
following command.
BigIron RX# show dot1x mac-session
Port
-------------------------------------------------------------------------------
1/1
1/2
1/3
1/4
1/5
Syntax: show dot1x mac-session [brief | [begin <expression> | exclude <expression> | include
Table 155
TABLE 155
This field...
Port
MAC
Username
Vlan
Auth-State
ACL
MAC
Age
978
MAC Username
0050.da0b.8cd7 Mary M
0050.da0b.8cb3 adminmorn
0050.da0b.8bef reports
0010.5a1f.6a63 testgroup
0050.da1a.ff7e admineve
<expression>]]
describes the information displayed by the show dot1x mac-session command.
Output from the show dot1x mac-session command
Displays...
The port on which the dot1x-mac-session exists.
The MAC address of the Client
The username used for RADIUS authentication.
The VLAN to which the port is currently assigned.
The authentication state of the dot1x-mac-session. This can be one of
the following.
permit – The Client has been successfully authenticated, and traffic
from the Client is being forwarded normally.
blocked – Authentication failed for the Client, and traffic from the Client
is being dropped in hardware.
restricted – Authentication failed for the Client, but traffic from the Client
is allowed in the restricted VLAN only.
init - The Client is in is in the process of 802.1x authentication, or has
not started the authentication process.
Whether or not an IP ACL is applied to incoming (i) and outgoing (o)
traffic on the interface
Whether or not a MAC filter is applied to the port.
The software age of the dot1x-mac-session.
VLAN Auth State ACL|MAC
i|o|f
1 DENIED n|n|n
4094 PERMITTED y|n|n
4094 PERMITTED y|n|n
4094 PERMITTED y|n|n
4094 PERMITTED y|n|n
BigIron RX Series Configuration Guide
53-1001810-01
Age
0
0
0
0
0