Ip Receive Access List - Dell PowerConnect B-RX Configuration Manual

NOTE
This feature is currently not applicable to IPv6 traffic.
To specify the ECMP default route, enter a command such as the following.
BigIron RX(config)# ip load-sharing default-route
Syntax: [no] ip load-sharing [<num> l <default-route>]
The <num> parameter specifies the number of paths and can be from 2 – 8.
The <default-router> parameter specifies the ECMP load sharing.
DIsplaying the ECMP load sharing
Use the show run command to display the ECMP load sharing.
BigIron RX(config)#show run
========show run =====================
!
logging console
hostname RW
ip route 0.0.0.0/0 100.1.1.2
ip route 0.0.0.0/0 100.1.2.2
ip route 0.0.0.0/0 100.1.3.2
ip route 0.0.0.0/0 100.1.4.2
ip route 10.0.0.0/8 10.43.2.1
ip route 40.0.0.0/24 100.1.1.2
ip load-sharing default-route
Use the show ip route command to display the traffic that will now be sent over all 4 links load
balanced instead of being on only 1 link.
BigIron RX#show ip route
Total number of IP routes: 9
Type Codes - B:BGP D:Connected I:ISIS S:Static R:RIP O:OSPF; Cost - Dist/Metric
Destination Gateway Port Cost Type
1 0.0.0.0/0 100.1.1.2 eth 7/1 1/1 S
0.0.0.0/0 100.1.2.2 eth 7/2 1/1 S
0.0.0.0/0 100.1.3.2 eth 7/3 1/1 S
0.0.0.0/0 100.1.4.2 eth 7/4 1/1 S
2 10.0.0.0/8 10.43.2.1 mgmt 1 1/1 S
3 10.43.2.0/24 DIRECT mgmt 1 0/0 D
4 40.0.0.0/24 100.1.1.2 eth 7/1 1/1 S
5 70.1.1.0/24 DIRECT eth 7/9 0/0 D
6 100.1.1.0/24 DIRECT eth 7/1 0/0 D
7 100.1.2.0/24 DIRECT eth 7/2 0/0 D
8 100.1.3.0/24 DIRECT eth 7/3 0/0 D
9 100.1.4.0/24 DIRECT eth 7/4 0/0 D

IP receive access list

The IP receive access list feature uses IPv4 ACLs to filter the packets intended for the management
process to protect the management module from being overloaded with heavy traffic that was sent
to one of the Layer 3 Switch IP interfaces. The feature applies to IPv4 unicast and multicast
packets.
BigIron RX Series Configuration Guide
53-1001810-01
Configuring forwarding parameters
7
205