Clearing Ipv6 Neighbor Information; Clearing Ipv6 Routes From The Ipv6 Route Table - Dell PowerConnect B-RX Configuration Manual

You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373. You must specify the <prefix-length> parameter as a decimal value. A
slash mark (/) must follow the <ipv6-prefix> parameter and precede the <prefix-length>
parameter.
You must specify the <ipv6-address> parameter in hexadecimal using 16-bit values between
colons as documented in RFC 2373.
The ethernet | tunnel | ve parameter specifies the interfaces for which you can remove cache
entries. If you specify an Ethernet interface, also specify the port number associated with the
interface. If you specify a VE or tunnel interface, also specify the VE or tunnel number, respectively.

Clearing IPv6 neighbor information

You can remove all entries from the IPv6 neighbor table or specify an entry based on the following:
•
•
•
For example, to remove entries for Ethernet interface 3/1, enter the following command at the
Privileged EXEC level or any of the CONFIG levels of the CLI.
BigIron RX# clear ipv6 neighbor ethernet 3/1
Syntax: clear ipv6 neighbor [<ipv6-prefix>/<prefix-length> | <ipv6-address> | ethernet <port> |
You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373. You must specify the <prefix-length> parameter as a decimal value. A
slash mark (/) must follow the <ipv6-prefix> parameter and precede the <prefix-length>
parameter.
You must specify the <ipv6-address> parameter in hexadecimal using 16-bit values between
colons as documented in RFC 2373.
The ethernet | ve parameter specifies the interfaces for which you can remove cache entries. If you
specify an Ethernet interface, also specify the port number associated with the interface. If you
specify a VE, also specify the VE number.

Clearing IPv6 routes from the IPv6 route table

You can clear all IPv6 routes or only those routes associated with a particular IPv6 prefix from the
IPv6 route table and reset the routes.
For example, to clear IPv6 routes associated with the prefix 2000:7838::/32, enter the following
command at the Privileged EXEC level or any of the Config levels of the CLI.
BigIron RX# clear ipv6 route 2000:7838::/32
Syntax: clear ipv6 route [<ipv6-prefix>/<prefix-length>]
The <ipv6-prefix>/<prefix-length> parameter clears routes associated with a particular IPv6 prefix.
You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373. You must specify the <prefix-length> parameter as a decimal value. A
slash mark (/) must follow the <ipv6-prefix> parameter and precede the <prefix-length>
parameter.
BigIron RX Series Configuration Guide
53-1001810-01
IPv6 prefix.
IPv6 address.
Interface type.
ve <number>]
Clearing global IPv6 information
43
1093