Displaying Interface Information - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series configuration guide v02.7.02
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

29
Displaying IPv4 IS-IS information
TABLE 132
Message level
Notification
Notification
Notification

Displaying interface information

To display information about the device's IS-IS interfaces, enter the following command at any level
of the CLI.
BigIron RX# show isis interface
Total number of IS-IS Interfaces: 1
Interface: Eth 7/1
Circuit State: UP Circuit Mode: LEVEL-1-2
Circuit Type: BCAST Passive State: FALSE
Circuit Number: 0x01, MTU: 1497
Authentication password: None
Level-1 Metric: 10, Level-1 Priority: 64
Level-1 Hello Interval: 10 Level-1 Hello Multiplier: 3
Level-1 Designated IS: RX-01 Level-1 DIS Changes: 8
Level-2 Metric: 10, Level-2 Priority: 64
Level-2 Hello Interval: 10 Level-2 Hello Multiplier: 3
Level-2 Designated IS: RX-01 Level-2 DIS Changes: 8
Next IS-IS LAN Level-1 Hello in 9 seconds
Next IS-IS LAN Level-2 Hello in 5 seconds
Number of active Level-1 adjacencies: 1
Number of active Level-2 adjacencies: 1
Circuit State Changes: 1 Circuit Adjacencies State Changes: 6
Rejected Adjacencies: 0
Circuit Authentication Fails: 0 Bad LSPs: 0
Control Messages Sent: 602 Control Messages Received: 2212
IP Enabled: TRUE
IP Address and Subnet Mask:
Syntax: show isis interface [brief | ethernet <slot-number>/<port-number> | loopback <number>
906
IS-IS Syslog messages (Continued)
Message
ISIS L2 ADJACENCY UP <system-id> on
interface <interface-id>
ISIS ENTERED INTO OVERLOAD STATE
ISIS EXITED FROM OVERLOAD STATE
4.1.1.2
255.255.255.0
| ve <number>]
Explanation
The BigIron RX's adjacency with this Level-2
IS has come up.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
The BigIron RX has set the overload bit to (1),
indicating that the BigIron RX's IS-IS
resources are overloaded.
The BigIron RX has set the overload bit to off
(0), indicating that the BigIron RX's IS-IS
resources are no longer overloaded.
BigIron RX Series Configuration Guide
53-1001810-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Brocade dcx-4sBrocade dcx

Table of Contents