Displaying The Routes Bgp4 Has Placed In The Ip Route Table - Dell PowerConnect B-RX Configuration Manual

TABLE 126
This field...
Aggregator
Atomic
Local Pref
Communities
AS Path

Displaying the routes BGP4 has placed in the IP route table

The IP route table indicates the routes it has received from BGP4 by listing "BGP" as the route type.
You can view the IP route table.
To display the IP route table, enter the following command.
BigIron RX# show ip route
Syntax: show ip route [<ip-addr> | <num> | bgp | ospf | rip | isis]
Here is an example of the information displayed by this command. Notice that most of the routes in
this example have type "B", indicating that their source is BGP4.
BigIron RX# show ip route
Type Codes - B:BGP D:Connected I:ISIS S:Static R:RIP O:OSPF; Cost - Dist/Metric
1
2
BigIron RX Series Configuration Guide
53-1001810-01
BGP4 route-attribute entries information (Continued)
Destination Gateway
130.130.130.0/24 11.11.11.1
130.130.131.0/24 11.11.11.1
Displaying BGP4 information
Displays...
Aggregator information:
•
AS Number shows the AS in which the network information in the
attribute set was aggregated. This value applies only to aggregated
routes and is otherwise 0.
•
Router-ID shows the router that originated this aggregator.
Whether the network information in this set of attributes has been
aggregated and this aggregation has resulted in information loss.
•
TRUE – Indicates information loss has occurred
•
FALSE – Indicates no information loss has occurred
NOTE: Information loss under these circumstances is a normal part of
BGP4 and does not indicate an error.
The degree of preference for routes that use this set of attributes
relative to other routes in the local AS.
The communities that routes with this set of attributes are in.
The ASs through which routes with this set of attributes have passed.
The local AS is shown in parentheses.
Port Cost
ve 1 200/0
ve 1 200/0
26
Type
B
B
847