Handshake Mechanisms - Dell PowerConnect B-RX Configuration Manual

•
In contrast to the 802.1D standard, the RSTP standard does not have any bridge specific timers. All
timers in the CLI are applied on a per-port basis, even though they are configured under bridge
parameters.
RSTP state machines attempt to quickly place the ports into either a forwarding or discarding state.
Root ports are quickly placed in forwarding state when both of the following events occur:
•
•
When a the role of Root port is given to another port, the old Root port is instructed to reroot. The
old Root port goes into a discarding state and negotiates with its peer port for a new role and a new
state. A peer port is the port on the other bridge to which the port is connected. For example, in
Figure
A port with a Designated role is quickly placed into a forwarding state if one of the following occurs:
•
•
However, a Designated port that is attached to an Alternate port or a Backup port must wait until
the forward delay timer expires twice on that port while it is still in a Designated role, before it can
proceed to the forwarding state.
Backup ports are quickly placed into discarding states.
Alternate ports are quickly placed into discarding states.
A port operating in RSTP mode may enter a learning state to allow MAC address entries to be added
to the filtering database; however, this state is transient and lasts only a few milliseconds, if the
port is operating in RSTP mode and if the port meets the conditions for rapid transition.

Handshake mechanisms

To rapidly transition a Designated or Root port into a forwarding state, the Port Role Transition state
machine uses handshake mechanisms to ensure loop free operations. It uses one type of
handshake if no Root port has been assigned on a bridge, and another type if a Root port has
already been assigned.
Handshake when no root port is elected
If a Root port has not been assigned on a bridge, RSTP uses the Proposing -> Proposed -> Sync ->
Synced -> Agreed handshake:
•
•
BigIron RX Series Configuration Guide
53-1001810-01
Port Timers – This state machine is responsible for triggering any of the state machines
described above, based on expiration of specific port timers.
It is assigned to be the Root port.
It receives an RST BPDU with a proposal flag from a Designated port. The proposal flag is sent
by ports with a Designated role when they are ready to move into a forwarding state.
43, Port1 of Switch 200 is the peer port of Port2 of Switch 100.
The Designated port receives an RST BPDU that contains an agreement flag from a Root port
The Designated port is an Edge port
Proposing – The Designated port on the root bridge sends an RST BPDU packet to its peer port
that contains a proposal flag. The proposal flag is a signal that indicates that the Designated
port is ready to put itself in a forwarding state
send this flag in its RST BPDU until it is placed in a forwarding state
operate in 802.1D mode. (Refer to
Proposed – When a port receives an RST BPDU with a proposal flag from the Designated port
on its point-to-point link, it asserts the Proposed signal and one of the following occurs
(Figure 43):
(Figure 43). The Designated port continues to
"Compatibility of RSTP with 802.1D"
13
State machines
(Figure 46) or is forced to
on page 374)
353