Configuring Additional Vrrp And Vrrpe Parameters; Authentication Type - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series configuration guide v02.7.02
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

Configuring additional VRRP and VRRPE parameters

You can modify the following VRRP and VRRPE parameters on each individual virtual router. These
parameters apply to both protocols:
Refer to
defaults.

Authentication type

If the interfaces on which you configure the virtual router use authentication, the VRRP or VRRPE
packets on those interfaces also must use the same authentication. Brocade's implementation of
VRRP and VRRPE supports the following authentication types:
To configure the interface on Router1 for simple-password authentication using the password
"ourpword", enter the following commands.
Configuring router 1
Router1(config)# inter e 1/6
Router1(config-if-e10000-1/6)# ip vrrp auth-type simple-text-auth ourpword
Configuring router 2
Router2(config)# inter e 1/5
Router2(config-if-e10000-1/5)# ip vrrp auth-type simple-text-auth ourpword
Syntax: ip vrrp auth-type no-auth | simple-text-auth <auth-data>
The auth-type no-auth parameter indicates that the virtual router and the interface it is configured
on do not use authentication.
BigIron RX Series Configuration Guide
53-1001810-01
Authentication type (if the interfaces on which you configure the virtual router use
authentication)
Backup priority
Suppression of RIP advertisements on Backup routes for the backed up interface
Hello interval
Dead interval
Backup Hello messages and message timer (Backup advertisement)
Track port
Track priority
Backup preempt mode
Master Router Abdication and Reinstatement
"VRRP and VRRPE parameters"
No authentication – The interfaces do not use authentication. This is the default for VRRP and
VRRPE.
Simple – The interfaces use a simple text-string as a password in packets sent on the
interface. If the interfaces use simple password authentication, the virtual router configured
on the interfaces must use the same authentication type and the same password.
Configuring additional VRRP and VRRPE parameters
on page 446 for a summary of the parameters and their
17
451

Advertisement

Table of Contents
loading

This manual is also suitable for:

Brocade dcx-4sBrocade dcx

Table of Contents