Dell PowerConnect B-RX Configuration Manual page 373

For example, in
whereas, the 802.1Q tag for incoming traffic is 8100.
To configure 802.1 Q-in-Q tagging as shown in
the untagged edge links of devices C and D.
BigIron RX(config)# tag-type 9100 e3/1 to 3/2
BigIron RX(config)# aggregated-vlan
Note that since ports 11 and 12 belong to the port region 1 – 12, the 802.1Q tag actually applies
to ports 1 – 12.
Syntax: [no] tag-type <num> [ethernet <slot-number>/<port-number> [to
The <num> parameter specifies the tag-type number and can be a hexadecimal value from 0 - ffff.
The default is 8100.
The ethernet <port number> to <port number> parameter specifies the ports that will use the
defined 802.1Q tag. This parameter operates with the following rules:
•
•
BigIron RX Series Configuration Guide
53-1001810-01
Figure 27, the 802.1Q tag on the untagged edge links (ports 11 and 12) is 9100,
<slot-number>/<port-number>]]
If you specify a single port number, the 802.1Q tag applies only to that port. You can use the
show running-config command to view how the command has been applied.
If you do not specify a port or range of ports, the 802.1Q tag applies to all Ethernet ports on the
device.
Configuring 802.1q-in-q tagging
Figure 27, enter commands such as the following on
11
301