Displaying Error Statistics - Dell PowerConnect B-RX Configuration Manual

TABLE 137
This field...
Level-2 LSP
Level-1 CSNP
Level-2 CSNP
Level-1 PSNP
Level-2 PSNP

Displaying error statistics

To display IS-IS error statistics, enter the following command at any level of the CLI.
BigIron RX# show isis counts
Area Mismatch: 0
Max Area Mismatch: 0
System ID Length Mismatch: 0
Authentication Fail: 0
Corrupted LSP: 0
LSP Sequence Number Skipped: 0
LSP Max Sequence Number Exceeded: 0
Level-1 Database Overload: 0
Level-2 Database Overload: 0
Our LSP Purged: 0
Syntax: show isis counts
This display shows the following information.
TABLE 138
This field...
Area Mismatch
Max Area Mismatch
System ID Length Mismatch
Authentication Fail
Corrupted LSP
LSP Sequence Number Skipped
LSP Max Sequence Number Exceeded
BigIron RX Series Configuration Guide
53-1001810-01
IS-IS traffic statistics (Continued)
Displays...
The number of Level-2 link-state PDUs sent and received by the BigIron
RX.
The number of Level-1 Complete Sequence Number PDUs (CSNPs) sent
and received by the BigIron RX.
The number of Level-2 CSNPs sent and received by the BigIron RX.
The number of Level-1 Partial Sequence Number PDUs (PSNPs) sent
and received by the BigIron RX.
The number of Level-2 PSNPs sent and received by the BigIron RX.
IS-IS error statistics
Displays...
The number of times the BigIron RX interface was unable to create a
Level-1 adjacency with a neighbor because the BigIron RX interface and
the neighbor did not have any areas in common.
The number of times the BigIron RX received a PDU whose value for
maximum number of area addresses did not match the BigIron RX's
value for maximum number of area addresses.
The number of times the BigIron RX received a PDU whose ID field was a
different length than the ID field length configured on the BigIron RX.
The BigIron RX is configured to authenticate IS-IS packets in the packet's
domain or area, but the packet did not contain the correct password.
The number of times the BigIron RX detected a corrupted LSP in the
device's memory.
The number of times the BigIron RX received an LSP with a sequence
number that was more than 1 higher than the sequence number of the
previous LSP received from the same neighbor.
The number of times the BigIron RX attempted to set an LSP sequence
number to a value higher than the highest number in the CSNP sent by
the Designated IS.
Displaying IPv4 IS-IS information
29
913