Dell PowerConnect B-RX Configuration Manual page 983

TABLE 135
This field...
P
OL
Displaying detailed information
To display detailed information for all the LSPs in the BigIron RX's LSP databases, enter the
following command at any level of the CLI.
BigIron RX# show isis database detail
IS-IS Level-1 Link State Database
LSPID
RX.00-00*
Area Address:
NLPID:
Hostname:
Metric:
Metric:
IS-IS Level-2 Link State Database
LSPID
RX.00-00*
Area Address:
NLPID:
Hostname:
IP address:
Metric:
Metric:
Metric:
Metric:
TABLE 136
This field...
LSPID
LSP Seq Num
LSP Checksum
LSP Holdtime
ATT/P/OL
Area Address
NLPID
BigIron RX Series Configuration Guide
53-1001810-01
IS-IS summary LSP database information (Continued)
Displays...
The value in the Partition option field of the LSP. The field can have one
of the following values:
•
•
The value in the LSP database overload field of the LSP. The field can
have one of the following values:
•
•
LSP Seq Num
0x0000000b
49
CC(IP)
RX
10 IP-Internal 4.1.1.0/24
10 IS RX.01
LSP Seq Num
0x0000000d
49
CC(IP)
RX
4.1.1.1
10 IP-Internal 4.1.1.0/24
10 IP-Internal 192.85.1.0/24
10 IS RX.01
10 IS RX.02
IS-IS detailed LSP database information
Displays...
See the description of the summary display.
See the description of the summary display.
See the description of the summary display.
See the description of the summary display.
See the description of the summary display.
The address of the area.
The Network Layer Protocol Identifier (NLPID), which specifies the
protocol the IS that sent the LSP is using. Usually, this value is "CC(IP)".
Displaying IPv4 IS-IS information
0 – The IS that sent the LSP does not support partition repair.
1 – The IS that sent the LSP supports partition repair.
0 – The overload bit is off.
1 – The overload bit is on, indicating that the IS that sent the LSP is
overloaded and should not be used as a IS-IS transit router for that
level.
LSP Checksum LSP Holdtime
0x23fb 971
Up-bit: 0
LSP Checksum LSP Holdtime
0x7d97 903
Up-bit: 0
Up-bit: 0
29
ATT/P/OL
1/0/0
ATT/P/OL
1/0/0
911