Dell PowerConnect B-RX Configuration Manual page 530

17
Displaying VRRP and VRRPE information
Syntax: show ip vrrp [brief | ethernet <slot>/<portnum> | ve <num> | stat]
Syntax: show ip vrrp-extended [brief | ethernet <slot>/<portnum> | ve <num> | stat]
The brief parameter displays summary information. Refer to
page 456.
The ethernet <slot>/<portnum> parameter specifies an Ethernet port. If you use this parameter,
the command displays VRRP or VRRPE information only for the specified port.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command
displays VRRP or VRRPE information only for the specified virtual interface.
The statistic parameter displays statistics. Refer to
This display shows the following information.
TABLE 86
This field...
Total number of VRRP (or
VRRP-Extended) routers defined
Interface parameters
Interface
auth-type
Virtual router parameters
VRID
state
administrative-status
458
CLI display of VRRP or VRRPE detailed information
Displays...
The total number of virtual routers configured on this device.
NOTE: The total applies only to the protocol the device is running. For
The interface on which VRRP or VRRPE is configured. If VRRP or VRRPE
is configured on multiple interfaces, information for each interface is
listed separately.
The authentication type enabled on the interface.
The virtual router configured on this interface. If multiple virtual routers
are configured on the interface, information for each virtual router is
listed separately.
This device's VRRP or VRRPE state for the virtual router. The state can be
one of the following:
•
NOTE: If the state is "initialize" and the mode is incomplete, make sure
•
•
The administrative status of the virtual router. The administrative status
can be one of the following:
•
•
"Displaying summary information"
"Displaying statistics"
example, if the device is running VRRPE, the total applies only to
VRRPE routers.
initialize – The virtual router is not enabled (activated). If the state
remains "initialize" after you activate the virtual router, make sure
that the virtual router is also configured on the other routers and
that the routers can communicate with each other.
you have specified the IP address for the virtual router.
backup – This device is a Backup for the virtual router.
master – This device is the Master for the virtual router.
disabled – The virtual router is configured on the interface but
VRRP or VRRPE has not been activated on the interface.
enabled – VRRP or VRRPE has been activated on the interface.
on page 460.
BigIron RX Series Configuration Guide
53-1001810-01
on