Clearing Ip Routes; Displaying Ip Traffic Statistics - Dell PowerConnect B-RX Configuration Manual

TABLE 54
This field...
Type
Uptime

Clearing IP routes

If needed, you can clear the entire route table or specific individual routes.
To clear all routes from the IP route table.
BigIron RX# clear ip route
To clear route 209.157.22.0/24 from the IP routing table.
BigIron RX# clear ip route 209.157.22.0/24
Syntax: clear ip route [<ip-addr> <ip-mask> | <ip-addr>/<mask-bits>]

Displaying IP traffic statistics

To display IP traffic statistics, enter the following command at any CLI level.
NOTE
In the device, only those packets that are forwarded or generated by the CPU are included in the IP
traffic statistics. Hardware forwarded packets are not included.
BigIron RX Series Configuration Guide
53-1001810-01
CLI display of IP route table (Continued)
Displays...
The route type, which can be one of the following:
•
B – The route was learned from BGP.
•
D – The destination is directly connected to this device.
•
R – The route was learned from RIP.
•
S – The route is a static route.
•
* – The route is a candidate default route.
•
O – The route is an OSPF route. Unless you use the ospf option to
display the route table, "O" is used for all OSPF routes. If you do use
the ospf option, the following type codes are used:
•
O – OSPF intra area route (within the same area).
•
IA – The route is an OSPF inter area route (a route that passes from one
area into another).
•
E1 – The route is an OSPF external type 1 route.
•
E2 – The route is an OSPF external type 2 route.
The elapse time since an IP route was installed.
Displaying IP information
7
223