Displaying Ipv6 Interface Information - Dell PowerConnect B-RX Configuration Manual

The <index-number> parameter restricts the display to the entry for the specified index number
and subsequent entries.
The <ipv6-prefix>/<prefix-length> parameter restricts the display to the entries for the specified
IPv6 prefix. You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the <prefix-length> parameter as a
decimal value. A slash mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The ethernet | ve | tunnel parameter restricts the display to the entries for the specified interface.
The <ipv6-address> parameter restricts the display to the entries for the specified IPv6 address.
You must specify this parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373.
If you specify an Ethernet interface, also specify the port number associated with the interface. If
you specify a VE interface, also specify the VE number. If you specify a tunnel interface, also specify
the tunnel number.
This display shows the following information.
TABLE 167
This field...
Total number of cache entries
IPv6 Address
Next Hop
Port

Displaying IPv6 interface information

To display IPv6 interface information, enter the following command at any CLI level.
BigIron RX# show ipv6 interface
Routing Protocols : R - RIP
Interface
Ethernet 3/3
Ethernet 3/5
Ethernet 3/17
Ethernet 3/19
VE 4
VE 14
Loopback 1
Loopback 2
Loopback 3
Syntax: show ipv6 interface [<interface> [<port-number> |<number>]]
The <interface> parameter displays detailed information for a specified interface. For the interface,
you can specify the Ethernet, loopback, tunnel, or VE keywords. If you specify an Ethernet interface,
also specify the port number associated with the interface. If you specify a loopback, tunnel, or VE
interface, also specify the number associated with the interface.
This display shows the following information.
BigIron RX Series Configuration Guide
53-1001810-01
IPv6 cache information fields
Displays...
The number of entries in the cache table.
The host IPv6 address.
The next hop, which can be one of the following:
•
•
•
The port on which the entry was learned.
O - OSPF I - ISIS
Status Routing
down/down R
down/down
up/up
up/up
down/down
up/up
up/up
up/up
up/up
Displaying global IPv6 information
Direct – The next hop is directly connected to the router.
Local – The next hop is originated on this router.
<ipv6 address> – The IPv6 address of the next hop.
Global Unicast Address
2017::c017:101/64
2019::c019:101/64
2024::c060:101/64
::1/128
2005::303:303/128
43
1095