Displaying Summary Mbgp Information - Dell PowerConnect B-RX Configuration Manual

27
Displaying MBGP information
TABLE 128
Command
show ip mbgp <ip-addr>[/<prefix>]
show ip mbgp attribute-entries
show ip mbgp dampened-paths
show ip mbgp flap-statistics
show ip mbgp filtered-routes
The following sections show examples of some of the MBGP show commands. An example of the
show ip mroute command is also included. This command displays the IP multicast route table.

Displaying summary MBGP information

To display summary MBGP information, enter the following command at any CLI prompt.
BigIron RX# show ip mbgp summary
BGP4 Summary
Router ID: 9.9.9.1
Confederation Identifier : not configured
Confederation Peers:
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 1, UP: 1
Number of Routes Installed : 5677
Number of Routes Advertising to All Neighbors : 5673
Number of Attribute Entries Installed : 3
Neighbor Address
166.1.1.2
Syntax: show ip mbgp summary
NOTE
This command's display looks similar to the display for the show ip bgp config command. However,
the show ip mbgp config command lists only the MBGP neighbors, whereas the show ip bgp config
command lists only the BGP neighbors.
862
MBGP Show commands (Continued)
Description
Displays a specific MBGP route.
Displays MBGP route attributes.
Displays MBGP paths that have been dampened by route flap
dampening.
Displays route flap dampening statistics.
Displays routes that have been filtered out.
Local AS Number : 200
AS# State
200 ESTAB
Time Rt:Accepted Filtered Sent
0h24m54s 3
BigIron RX Series Configuration Guide
ToSend
0 5673 0
53-1001810-01