Setting The Frrp Timers; Clearing The Frrp Counters; Viewing The Frrp Configuration; Viewing The Frrp Information - Dell S3048-ON Configuration Manual

no disable

Setting the FRRP Timers

To set the FRRP timers, use the following command.
NOTE: Set the Dead-Interval time 3 times the Hello-Interval.
• Enter the desired intervals for Hello-Interval or Dead-Interval times.
CONFIG-FRRP mode.
timer {hello-interval|dead-interval} milliseconds
• Hello-Interval: the range is from 50 to 2000, in increments of 50 (default is 500).
• Dead-Interval: the range is from 50 to 6000, in increments of 50 (default is 1500).

Clearing the FRRP Counters

To clear the FRRP counters, use one of the following commands.
• Clear the counters associated with this Ring ID.
EXEC PRIVELEGED mode.
clear frrp ring-id
Ring ID: the range is from 1 to 255.
• Clear the counters associated with all FRRP groups.
EXEC PRIVELEGED mode.
clear frrp

Viewing the FRRP Configuration

To view the configuration for the FRRP group, use the following command.
• Show the configuration for this FRRP group.
CONFIG-FRRP mode.
show configuration

Viewing the FRRP Information

To view general FRRP information, use one of the following commands.
• Show the information for the identified FRRP group.
EXEC or EXEC PRIVELEGED mode.
show frrp ring-id
Ring ID: the range is from 1 to 255.
• Show the state of all FRRP groups.
EXEC or EXEC PRIVELEGED mode.
278 Force10 Resilient Ring Protocol (FRRP)