Dell PowerConnect B-RX Configuration Manual page 917

TABLE 125
This field...
Age
Next_Hop
Learned from Peer
Local_Pref
MED
Origin
Weight
Atomic
Aggregation ID
Aggregation AS
Originator
Cluster List
Learned From
Admin Distance
Adj_RIB_out
Communities
BigIron RX Series Configuration Guide
53-1001810-01
BGP4 route information (Continued)
Displays...
The last time an update occurred.
The next-hop router for reaching the network from the BigIron RX.
The IP address of the neighbor that sent this route.
The degree of preference for this route relative to other routes in the
local AS. When the BGP4 algorithm compares routes on the basis of
local preferences, the route with the higher local preference is chosen.
The preference can have a value from 0 – 4294967295.
The route's metric. If the route does not have a metric, this field is
blank.
The source of the route information. The origin can be one of the
following:
•
•
•
When BGP4 compares multiple routes to a destination to select the best
route, IGP is preferred over EGP and both are preferred over
INCOMPLETE.
The value that this router associates with routes from a specific
neighbor. For example, if the router receives routes to the same
destination from two BGP4 neighbors, the router prefers the route from
the neighbor with the larger weight.
Whether network information in this route has been aggregated and this
aggregation has resulted in information loss.
NOTE: Information loss under these circumstances is a normal part of
The router that originated this aggregator.
The AS in which the network information was aggregated. This value
applies only to aggregated routes and is otherwise 0.
The originator of the route in a route reflector environment.
The route-reflector clusters through which this route has passed.
The IP address of the neighbor from which the BigIron RX learned the
route.
The administrative distance of the route.
The number of neighbors to which the route has been or will be
advertised. This is the number of times the route has been selected as
the best route and placed in the Adj-RIB-Out (outbound queue) for a
BGP4 neighbor.
The communities the route is in.
Displaying BGP4 information
EGP – The routes with this set of attributes came to BGP through
EGP.
IGP – The routes with this set of attributes came to BGP through
IGP.
INCOMPLETE – The routes came from an origin other than one of
the above. For example, they may have been redistributed from
OSPF or RIP.
BGP4 and does not indicate an error.
26
845