Dell PowerConnect B-RX Configuration Manual page 903

TABLE 121
This field...
HoldTime
PeerGroup
Multihop-EBGP
RouteReflectorClient
SendCommunity
NextHopSelf
DefaultOriginate
MaximumPrefixLimit
RemovePrivateAs
RefreshCapability
CooperativeFilteringCapability
Distribute-list
Filter-list
Prefix-list
Route-map
Messages Sent
Messages Received
Last Update Time
BigIron RX Series Configuration Guide
53-1001810-01
BGP4 neighbor information (Continued)
Displays...
The hold time, which specifies how many seconds the router will wait for a
KEEPALIVE or UPDATE message from a BGP4 neighbor before deciding that
the neighbor is dead. Refer to
on page 787.
The name of the peer group the neighbor is in, if applicable.
Whether this option is enabled for the neighbor.
Whether this option is enabled for the neighbor.
Whether this option is enabled for the neighbor.
Whether this option is enabled for the neighbor.
Whether this option is enabled for the neighbor.
Lists the maximum number of prefixes the BigIron RX will accept from this
neighbor.
Whether this option is enabled for the neighbor.
Whether this BigIron RX has received confirmation from the neighbor that
the neighbor supports the dynamic refresh capability.
Whether the neighbor is enabled for cooperative route filtering.
Lists the distribute list parameters, if configured.
Lists the filter list parameters, if configured.
Lists the prefix list parameters, if configured.
Lists the route map parameters, if configured.
The number of messages this router has sent to the neighbor. The display
shows statistics for the following message types:
•
Open
•
Update
•
KeepAlive
•
Notification
•
Refresh-Req
The number of messages this router has received from the neighbor. The
message types are the same as for the Message Sent field.
Lists the last time updates were sent and received for the following:
•
NLRIs
•
Withdraws
Displaying BGP4 information
"Changing the keep alive time and hold time"
26
831